User's Manual

4. BACKUP Battery
Installing a Battery.
The GSM Phone is powered by a rechargeable Li-on battery. Use only Sungil approved battery.
1. Remove the battery cover gently.
2. Place the battery into the battery slot, making sure that the battery connector is securelyconnected to the corner
of the battery slot.
3. Place the Battery cover as shown.
Charging the Batter
The Battery is charged and powered by Li-on battery,and a travel adaptor comes with the
originalpackage. Use only Sungil approved battery to ensure the quality,and it is always advised that
phoneis connected to a permanent power source at all times.
Please note that Battery is for Emergency.
1. With Battery in position on the phone, plug in GSM Phone power adaptor to the back of the unit.
2. Plug your Power Adaptor to a standard AC Wall Outlet. When the battery is charged, it will
havepower plug display on the right end. When power is plugged off,phone goes into a battery
mode,and remaining battery power will be shown on the same right top end of LCD display
.
*Note : Do not remove the battery from the phone without unplugging the adapter while it is usingbattery.When the battery
is weak and only a few minutes of talk time remain, the battery sensor will letyou know by blinking the empty
Battery Strength icon (
). You will hear a warning tone and a“Battery is low” message will be repeated at
regular intervals on the display. When the batterybecomes too weak for the phone to operate in emergency, it will
be switched off automatically.