User's Manual

• To watch an assembly

video, go to

http://productvideo.co/

assembly/dsg/epic or

use your mobile phone

or smartphone to read

the QR code at the right.

• Assembly requires two persons.

• Place all parts in a cleared area and remove the

packing materials, except for the packing materi-

als on the upright. Do not dispose of the packing

materials until you nish all assembly steps.

• After shipping, there may be an oily substance

on the exterior of the treadmill. This is normal. If

there is an oily substance on the treadmill, wipe

it off with a soft cloth and a mild, non-abrasive

cleaner.

• Left parts are marked “L” or “Left” and right parts

are marked “R” or “Right.”

• To identify small parts, see page 6.

• Assembly requires the following tools:

the included hex keys

two adjustable wrenches

To avoid damaging parts, do not use power tools.

ASSEMBLY

1. Make sure that the power cord is unplugged.

Also, make sure to assemble the treadmill in

the location where it will be used. If there is a

strap around the treadmill, remove it.

With the help of a second person, hold both

sides of the Upright (96) securely and remove

the packing materials (A) at the same time.

Then, carefully raise the Upright (96) into the

vertical position so that the base of the Upright

rests flat on the floor. Be careful not to pinch

the power cord.

2. Identify the left leg extension assembly (B).

Insert the extension assembly into the left side of

the Upright (96). Attach the extension assembly

with two 5/16" x 3/4" Screws (1). Firmly tighten

the Screws.

Attach the right leg extension assembly (not

shown) to the right side of the Upright (96) in

the same way.

Base