Users Manual

IC Radiation Exposure Statement for Canada
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. To maintain compliance with IC RF exposure compliance requirements, please avoid
direct contact to the transmitting antenna during transmitting. End users must follow the specific
operating instructions for satisfying RF exposure compliance.
Operation is subject to the following two conditions:
• This device may not cause interference and
• This device must accept any interference, including interference that may cause undesired
operation of the device.
To prevent radio interference to the licensed service (i.e. co-channel Mobile Satellite systems) this
device is intended to be operated indoors and away from windows to provide maximum shielding.
Equipment (or its transmit antenna) that is installed outdoors is subject to licensing.
This device complies with Industry Canada licence-exempt RSS standard(s). CAN ICES-3(B)/NMB-3(B)
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device is below the Industry Canada (IC) radio
frequency exposure limits. The Wireless Device should be used in such a manner such that the
potential for human contact during normal operation is minimized.
This device has also been evaluated and shown compliant with the IC RF Exposure limits under
mobile exposure conditions (antennas are greater than 20cm from a person’s body).
Déclaration d’Industrie Canada relative à l’exposition aux ondes radio
Cet appareil est conforme aux limites d’exposition aux radiations d’Industrie Canada définies pour
un environnement non-contrôlé. Pour maintenir la conformité avec les exigences d’exposition RF
d’IC, veuillez éviter tout contact direct avec l’antenne pendant l’émission. Les utilisateurs finaux
doivent suivre les instructions de fonctionnement spécifiques pour satisfaire la conformité aux
expositions RF. Son utilisation est sujette aux deux conditions suivantes:
• Cet appareil ne peut pas causer d’interférence, et
• Cet appareil doit accepter toute interférence, y compris les interférences
qui pourraient causer un fonctionnement non souhaité de l’appareil.