Owner manual
inverse
127 becomes 0 and 0 becomes 127. This way you may inverse the curse of a sensor. With an
expression pedal, for example, you’ll be able to inverse its curse.
status
on/off
The status eld indicates whether the signal on an analogue input should be converted into a digi-
tal message or not. This eld may be set to ON or OFF. If the eld is set to OFF, the input is said to
be inactive and no message relating to that input will be generated, even if a signal does physically
enter the device. If the eld is switched back to ON, the input is active and its associated message
will be sent each time the signal connected to that input varies in level.
Note:The smaller the number of active inputs is, the less data will be transmitted avoiding proces-
sor computation.
zoom and offset
zoom: max/mid/low/off on 7
offset: -127 to +127
Eobody2HF / parameters
0
127
127
Digital value
(12 bits)
MIDI data
(7 bits)
MIDI conversion
zoom setting
=
real sensor range
Offset
-127--
Want to stay in the 7-bit MIDI world...
Those two parameters (digital zoom and offset)
specify how the real range of an analogue input can
be mapped on a 7-bit MIDI value. As a matter of fact,
a sensor does not necessarily have a range equal
to the reference voltage of the Analogue to Digital
Converter. A custom scaled zoom has been imple-
mented on the digital value to take advantage of
the 12-bit resolution of the A/D converter. Then, the
user can select the sensor’s range within the 12 bits
dynamic by specifying a window size and an offset.
The selected range can then be converted into 7 bits
MIDI data without greatly increasing the quantication
step, as shown in the illustration.
The digital zoom & offset parameters may be very
useful to modulate a lter on a certain part of the
amplitude.
15