Operator's Manual

2.1.3 Replacing the Battery

Remove the battery compartment by lifting up on the locking cam lever and carefully sliding the

battery compartment away and up from the sight housing (Figure 3). After the battery compart-

ment is removed, slide the batteries out and replace them with a fresh set. The labels on the

bottom of battery compartment show the correct battery orientation. Always make sure the

gasket is free of dirt before the battery compartment is reinstalled or the seal may be compro-

mised. To reinstall the battery compartment, point the sight towards the ground and slide battery

compartment onto base. Make sure there is enough clearance between the contact and the

batteries to avoid bending the contacts. Hold the battery compartment down firmly against the

base and close the locking cam. Before you push down on cam lever, make sure the battery

compartment sits all the way down and is parallel to the base. Verify correct battery installation

immediately by turning on the sight and checking if the holographic reticle appears. If the bat-

teries are left in the sight backwards, they will be drained of their power.