Installation Guide

2. After you have veried the stability of the Wi-Fi, and found a suitable mounting location,
oer the base of the EO Mini Pro 3 to the installation location; make sure the surface is
at and level.
Level the EO Mini Pro 3 base and mark the position of the four holes. Take the
EO Mini Pro 3 base away and drill the four holes in the mounting surface.
Figure 2: EO Mini Pro 3 backplate.
3. Attach the EO Mini Pro 3 base to the wall using four screws provided. Ensure the charger
is secure and ush against the wall. Use packing washers if necessary for a ush t.
4. Strip and prepare the power cable and feed into the pre-made hole and stepped
grommet. A 25mm gland can be used if required.
Figure 3: Stripped power cable and entry point.