Installation Guide

2.0 PRE-REQUISITES
For installation of the EO Mini Pro 3 you will require the following:
1. Preferably a fully charged mobile device.
2. Wi-Fi analyser mobile app of your choice (refer to section 13.0).
3. Make sure the customer provides a suitable internet connection; either Wi-Fi or LAN.
4. Make sure the customer is available during the installation and provides their Wi-Fi SSID
so the Wi-Fi integrity tests can be carried out.
5. Provide appropriate cable glands based on your cable sizing and if using Ethernet cable.
6. Utilise a suitably sized hole cutter where additional Ethernet cable entry is required.
7. Locate the “Installer Access Label”.
To help in nding the best mounting location for the charger, we recommended that the
integrity of the Wi-Fi signal is checked before tting the device in its location.
Weak or unstable Wi-Fi signals may result in an unreliable or failed installation of the EO Mini
Pro 3. To check that the Wi-Fi signal is suitable please complete the following steps:
Utilise a suitable Wi-Fi analyser mobile device app to verify signal stability, strength, and
interference levels are adequate. Apps are available for both Android and iOS devices.
Using a Wi-Fi analyser app, stand at the intended charger installation location and measure
the RSSI signal to the client’s Wi-Fi router. The ideal value should be no greater than -60dB.
Where Wi-Fi integrity is not suitable, a few options exist:
1) Install a 2.4gHz Wi-Fi booster.
2) Use the hard-wired Ethernet option.
3) Re-locate the Wi-Fi router.
2.1 RESIDENTIAL WI-FI