User Guide
Table Of Contents
- IMPORTANT SAFEGUARDS
- Before using the electrical appliance, the followi
- 1.Read all instructions.
- 2.Before use check that the voltage of wall outlet c
- 3.Do not operate any appliance with a damaged cord o
- 4.If the supply cord is damaged it must be replaced
- 5.Unplug from outlet when not in use, before putting
- 6.Care shall be taken when handling the sharp cuttin
- 7.Do not let cord hang over edge of table or hot sur
- 8.Do not immerse the motorized base in liquid, or pl
- 9.Close supervision is necessary when your appliance
- 10.Ensure fingers are kept well away from moving part
- 11.Do not remove cover until blade has completely sto
- 12.Do not attempt operation without the cover being i
- 13.Do not run the appliance without load.
- 14.The use of accessory not recommended by the manufa
- 15.Immediately turn off the appliance and send it to
- 16.Remove the dust and other foreign objects from the
- 17.It is forbidden to disassemble, repair and rebuild
- 18.After each use, turn the grind control to the "1"
- 19.Do not plug and unplug the appliance with wet hand
- 20.Do not drag or bind the power cord.
- 21.Do not shake or drop the appliance strongly.
- 22.Check grinding chamber for presence of foreign obj
- 23. This appliance is not intended for used by person
- 24.Children should be supervised to ensure that they
- 25.Misuse may cause potential injury.
- 26.Do not operate the appliance for other than its in
- 27.Do not use outdoors.
- KNOW YOUR COFFEE GRINDER
- BEFORE THE FIRST TIME
- 1.Carefully unpack your coffee grinder and remove al
- 2.To remove any dust that may have accumulated durin
- 3.Rinse the bean box, bean box lid, ground coffee co
- OPERATION
- I. GRIND COFFEE BEANS AUTOMATICALLY
- II. GRIND COFFEE BEANS MANUALLY
6
3. Install the grinding unit onto the upper body as follows: Firstly, align the “ ” symbol on
the grinding unit with the “ ” symbol on the upper body (see Fig.2), then rotate the
grinding unit clockwise until the “ ” symbol aligns with the “ ” symbol (see Fig.3) . If
you want to remove the grinding unit, firstly run the coffee grinder to finish grinding the
beans in the bean box, then press down the release button and simultaneously turn the
grinding unit anticlockwise to remove the grinding unit from the upper body.
NOTE: The grinding unit is equipped with a microswitch so that it must be assembled in
position before operate, or the appliance will not work.
4. Install the bean box onto the bean box holder as follows: Firstly, align the “ ”symbol on
the bean box with the “ ” symbol on the upper body (see Fig.4), then rotate the bean box
clockwise until the “ ” symbol on the bean box aligns with the “ ” symbol on the bean box
holder (see Fig. 5). If you want to remove the bean box, firstly run the coffee grinder to finish
grinding the beans in the bean box, then rotate the bean box counterclockwise for 90°to
remove the bean box from the bean box holder.
Release button
Fig.2
Fig.3