Specifications

Tel：（ 86-760）88795588 Tax：（ 86-760）89935588

Zhongshan ENZD Electronics Ltd. Address：Guangdong Zhongshan JUYE Road No. 4

Magnet

Strip

The smaller one is a permanent magnet.

LED

Putting the main part and magnet together or take them apart will

trigger radio signals transmitted, and the blue LED will flash once. If

the product is at low voltage, instead of blue, red LED will flash.

Install

For installation, remove the film, and then paste the main

component and the magnet strip at each side of a door frame or a

window frame.

QR code

Sensor ID

Install

The door and window magnetic sensor can be installed using double-sided tape or screws. It

is easy to paste with double-sided tape, and there is almost no damage to the pasted object. It

is recommended that you use this kind of installation.

Paste with double-sided tape

1. Paste double-sided adhesive tape on the back of "window magnetic main component" and

"magnetic strip" of the sensor.

2. Tear off the surface of the double-sided tape with your fingers.

3. Paste the main component and magnetic strip to desired location.

Install with screws

You can use screws to fix it at a door frame. We recommend that you use this method to install

the main component, however because the magnet strip is small, we do not recommend this

method to install it.

1. Tighten the screws into a door frame.

2. Fix the main component and magnet strip to the door frame edge.

Be careful:

Pay attention to its mounting position. The middle section of the main component" should be

close to the magnet strip (but when installing, do not let the two close together).

If the door frame is wide, you can slot the door frame. Then place the main component and

magnet strip in the slotted position. In this way, it cannot be seen in the appearance.

"Magnet strip" is relatively small, we suggest you use double-sided tape to install it.

Warning: It cannot be installed on the door and window with magnetism, which may cause it

not function correctly, or even damage it.

Usage

You can put the main part and magnet together or take them apart to trigger radio signals

transmitted。For example, fix the main component and magnet strip to the door frame edge,

and then, if you open the door or close the door, it will transmit.

The sensor can be configured by using En and Ed APP, which can be downloaded from many

app stores. For usage, please refer to the manual of relevant software products. Identify the QR

code, you can download the APP.