Specifications

Tel：（ 86-760）88795588 Tax：（ 86-760）89935588
Zhongshan ENZD Electronics Ltd. Address：Guangdong Zhongshan JUYE Road No. 4
the infrared sensor
L
Take the infrared sensor as an example, connect the L line of
the infrared sensor
N
Output zero line
QR code
Product ID
Button
Change the usage mode
Warning: L and N cannot be connected reversely at the power supply end, otherwise safety
problems may occur (N line can be shared)
Installation
It is usually installed a infrared sensor or a smoke detector. You need to connect the blue and
red wires should be connected to power supply, and the terminal block is used to connect to
sensor output.
Warning: before installing it, please turn off the power supply to prevent electric shock.
1 Tighten the wire from the "Lin" interface and the hot wire from the distribution box.
2 Tighten the wire from the "Nin" interface and the zero wire from the distribution box
3 Connect the terminal L to the L of the infrared sensor.
4 Connect the terminal L1 to the L1 of the infrared sensor.
5 Connect terminal N to N of the infrared sensor.
Usage
The output of the product is connected with an infrared sensor, when someone is sensed
by the infrared sensor, the product will transmit. When no one is here, the product will also
transmit. Of course, you can also press the side key to send data.
The product can be set up by using En APP that is available from many APP Stores. For
usage, please refer to the manual of relevant software products. Identify the QR codes, you can
download the APP.
After you download the EN APP, you should click “Settings””Switch” ”+” ”SCAN QR CODE”
enter nameclick “Save”. Following the figure below.