Specifications

Diagrams are for reference only.

Consult the appropriate installation sheet for wiring details.

CONTROL PANELS

FIRESHIELDFIRESHIELD

FIRESHIELD

The FireShield family of conventional panels and accessories consists of three

panels, a DACT/dialer, serial remote annunciators and relays, city tie modules and

reverse polarity modules. FireShield’s ingenious initiating device circuits (IDCs) can

be programmed for one of eight configurations. Several of these configurations

allow the use of one zone to do the work of two. Verified detection circuits allow

detectors and contact devices (such as pull stations) to be installed on the same

zone. Combination circuits allow waterflow switches and their associated valve

tamper switches to be connected on a common two-wire IDC.

FireShield panels are available in three sizes and can be ordered with or without

the optional DACT:

FS302 – The three-zone FS302 is ideal for use as a sprinkler supervisory

panel. It includes three Class B IDCs and two Class B NACs.

FS502 – Factory configured with five Class B IDCs and two Class B NACs.

FS1004 – Factory configured with 10 Class B IDCs and four Class B NACs.

On the FS502 and FS104, IDCs or NACs can be paired to form single Class A

circuits.

All panels are available in a red or gray finish.

Following Page:Following Page:

Following Page:

The optional DACT/Dialer is a multifunction module that provides communica-

tions, modem capability, and LCD display functions. Its primary function is as a

Digital Alarm Communicator Transmitter (DACT).

The FSRSI is ideal for common system annunciation. It includes five LEDs and a

local silence/lamp test switch.

The FSRZI-A is used to indicate zones in the alarm state. It contains five red LEDs.

The panel can support two modules programmed for each selection.

The Remote Relay Module (FSRRM) can be configured to function in either a zone

relay mode or a common system mode.