Technical data

MENV-MINI4-02 Issue2 June 2006

Disable Zones or Sounders

DISABLE ZONES

To disable / isolate zones , enter code to activate controls and press the DISABLE button on the

keypad Now use buttons 1 – 4 to select which zone(s) to disable and then press ENTER when all

selections have been made. The disable mode will “time out” within 5 seconds if the ENTER button is

not pressed. It is possible to select any, or all zones, to be isolated at the same time. The disabled LED

will be illuminated. The fault LED of the zone that is disabled will be illuminated and the internal buzzer

will be sounding.

DISABLE SOUNDERS

To disable sounder circuits press the SOUND ALARMS button instead of buttons 1 – 4 (see above)

and then press ENTER. The sounder fault LED and the disabled LED will be illuminated.

To ‘enable’ the zones or sounder circuits again, simply repeat exactly the same procedure. WARNING

zones and sounder circuits that have been disabled cannot be enabled by the use of the RESET

button.

Remember to push each button slowly and deliberately. There is a half second delay on the

buttons to prevent misuse. The panel will bleep to acknowledge each push of the button.