Technical data

MENV-MINI4-02 Issue2 June 2006
20
Controls and Indications Continued
TABLE 2
P
TEST MODE
“Test mode” button. Puts zones into test mode. See relevant section, page
20.
Q
DISABLE
“Disable” button. To disable or isolate zones or sounder circuits. See relevant
section, page 21.
R
TEST LEDs
Pressing this button will cause all LEDs to illuminate briefly.
S
ENTER
“Enter” button. Used to acknowledge selection of zone or sounder circuits for
disablement. Also mutes internal fault buzzer when active and to enter code
number for controls activate.
T
SOUND ALARMS
“Sound alarms” button. To sound all bells and activate remote fire outputs for
full evacuation.
U
SILENCE ALARMS
“Silence alarms” button. To silence bells or sounders. The internal buzzer will
blip intermittently until the system has been reset.
V
RESET
“Reset” button. To reset system. When the panel is in fire condition reset will
only function if the “silence alarms” button has been pressed first.
W
DISABLE AUX
Isolates the remote fire and fault relays for system testing purposes. Press
again to reinstate them.