User guide

4Sight 87
Administrator Guide
Version 3.1
Basic setup
Adding a slave server
To set up the load balancing using the WebAdmin, follow these steps:
1. Click the
Load Balancing menu item. You will see a list of your
configured servers.
2. Check the
Enable Load Balancing check box to activate the load
balancing mechanism on the server.
3. Click on New Slave server to add a slave server to the list. The
following page is displayed:
4. Enter the IP address, followed by the port number of your slave server,
then click on the
Save Changes button.
NOTE If you do not specify the port number, the server will use the default
streaming port.