Operation Instructions 1. Reorient or relocate the receiving antenna. 2. Move the monitor and the receiver further away from each other. 3. Connect the monitor into an outlet on a circuit different from that to which the receiver is connected. 4. Consult your local dealer or a qualified technician. NOTICE: 1. 2. 3. The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Contert Safety Precautions First Setup Quick Installation Front View of the Product Main Menu Adjusting the picture Supported Timing Modes Technical Specification Care and Maintenance Troubleshooting 1 2 2 4 5 5 7 8 9 9
Safety Precautions English This monitor is manufactured and tested on a ground principle that a user’s safety comes first.However,improper use or installation may result danger to the monitor as well as to the user.Carefully go over the following WARNINGS before installation and keep this guide handy. WARNINGS: This monitor should be operated only at the correct power sources indicated on the label on the rear end of the monitor.
First Setup Congratulations for purchasing this monitor of high performance! This monitor comes with the following accessories: 1. 2. 3. 4. 5. LCD Monitor Owner's Manual Power Cord D-Sub Cable Audio Cable Quick Installation 1. Install / Remove the base Place the display onto the base. Align the display with the swivel on the base and plug the display into the base. Hold up the display and then snap the base by hand to remove it. Install Figure 1 2. 3. 4. 5. 6.
English Example: 1680X1050 @ 60 Hz Resolution Right-click on the Windows desktop > Properties > Settings > “Desktop Area”. Set the resolution. Refresh Rate (vertical frequency) See your graphic card’s user guide for instructions. Example: Deutsch Français Figure 2 1. 2. 3. 4.
Front View of the Product Figure 3 External Control Button 1. Auto Adjust Key/Exit 3. Increase>/ Input select 5. LED 2. Decrease button (②and ③ in fig. 3); see section “OSD Menu Functions”). 2. Press the OSD button MENU (④ in fig.
Main Menu English Deutsch Français Figure 4 The OSD Message Adjusting the picture The descriptions for function control LEDS Main Main Menu Menu Item Icon Brightness/ Contrast Image Adjust Sub Menu Item Brightness Contrast Black level Auto level H-Position V-Position Clock Phase Audio Volume Mute Description Controls the picture’s contrast, brightness, black level and auto level. Controls the picture’s horizontal position. Controls the picture’s vertical position. Sets up the internal clock.
Main Main Menu Menu Item Icon Sub Menu Item 6500K 9300K Colour Native Custom colour OSD Setup Advanced Information Description Regulates the color temperature settings. Activate the OSD window using the SEL/MENU button. Go to the Colour option by pressing the < or > buttons. Press the SEL/MENU button and < or > to select R, G or B. Then you can change the color valu ENGLISH, ESPAÑOL, FRANÇAIS, Language РУССКNŇ DEUTSCH, NETHERLANDS, ITALIANO, SVENSKA. OSD Controls the OSD menu’s horizontal position.
Supported Timing Modes Français 7 Deutsch Warning : Do not set the graphic card in your computer to exceed these maximum refresh rates.
Technical Specification Input signal Analog Dsub Digital DVI-D with HDCP Audio Display Type 20” LCD Widescreen Monitor Viewable Diagonal size 511mm/20in Native Resolution 1680 x 1050 Pixels Colors 16.7M colors Pixel Pitch 0.258 x 0.
Care and Maintenance z Troubleshooting No power z z z Make sure A/C power cord is securely connected to the power adapter and the power supply is firmly connected to the monitor. Plug another electrical device into the power outlet to verify that the outlet is supplying proper voltage. Make sure all signal cables are installed. Power on but no screen image z z Make sure the video cable supplied with the monitor is tightly secured to the video output prot on back of the computer.If not,tightly secure it.
