User Manual

16 energiSava

200

01423 810 810

SHOULD YOU ENCOUNTER ANY PROBLEMS

INSTALLING THIS UNIT, CALL US ON:

Filter indicator and reset:

• If on waking the remote control the summer bypass light ﬂashes (red),

the ﬁlters need to be replaced. Contact EnviroVent to order new ﬁlters.

• After replacement ﬁlters have been installed press and hold the

summer bypass button for 12 seconds to reset the ﬁlter indicator.

Pairing an extra remote control:

• Turn the unit off at the isolation point.

• Restore the power to the unit. For 20 seconds from restarting, the

unit will be in pairing mode.

• Press any button on the extra remote control once within the 20

seconds and the remote control will pair to the unit.

• Successful pairing is indicated by all three lights ﬂashing (green).

Fault indication:

• If a fault occurs with the MVHR unit, all lights on the remote control will

ﬂash (red). If it persists, call EnviroVent on 01423 810 810 for further help.

When the remote control batteries need to be replaced, unclip the switch

rear cover. The battery is located on the back of the cover. Replace the

batteries then clip the rear cover back on. The switch will remain paired

with the unit after battery replacement. The remote control uses 2x AAA

batteries. Dispose of the discarded batteries in a safe manner.