Instructions / Assembly

INSTALLATION & ASSEMBLY:
1. Turn off the power at the circuit breaker box.
2. Remove the fixture from the packaging.
3. Rest the luminaire on the T-Bar of the ceiling
suspension system in the desired location (Fig. 1).
4. From above the ceiling, secure the Troffer to T-Bar by
bending built in hooks (#1) on all four corners of the
fixture (Fig. 2).
5. If local code requires, tie a wire to at least two of the
four hooks (#1) located near each corner of the Troffer
to a structural member of the ceiling (Fig. 2).
6. Remove the access plate (#2) located on the back of
fixture. Locate the black and white fixture supply
wires (Fig. 2).
7. Remove one knockout in the access plate (#2)
(Fig. 3).
8. Thread the power supply wires through the
knockout hole in the access plate (#2).
9. Remove the access plate located on back of fixture
(#3) and locate the purple and grey dimming wires
(Fig. 3).
10. Remove one knockout in the access plate (#2)
(Fig. 3)
11. Thread the dimming wires through the knockout
hole in the access plate (#2).
12. Connect the black fixture wire to the black (+)
supply wire and connect the white fixture wire to the
white supply wire (-) using wire nuts. Connect the
supply ground wire to the fixture ground wire using
a wire nut (Fig. 4).
13. Connect the purple and grey fixture wires to
corresponding wires of the wall 0-10V dimmer (Fig. 5).
14. Restore power at the circuit breaker box.
Fig. 4
BLACK BLACK
WHITE WHITE
GROUND GROUND
FIXTURE WIRES SUPPLY WIRES
Fig. 5
PURPLE PURPLE
GREY GREY
FIXTURE WIRES DIMMER WIRES
Fig. 2
Fig. 3
Fig. 1
4