Instructions / Assembly

Fig. 6
Fig. 2
MODEL: ST4LSWDMDSC
ST4LSWDMDSCB
INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions. Failure to
do so may lead to electrical shock or fire, which may cause
injury or death.
________
CAUTION
WARNING – RISK OF FIRE: Turn off the main power at the
circuit breaker before installing the fixture, changing lamps,
or performing other maintenance in order to prevent possible
shock.
_________
GENERAL
All electrical connections must be in accordance with local,
and national electrical codes.
Prior to installation remove all protective plastic film covering
from the fixture.
Tools needed for installation: Phillips screwdriver, pliers.
_____________________________
ASSEMBLY AND INSTALLATION
1. Center the fixture over the outlet box and mark the location of
the fixture’s bracket slots onto the ceiling. Set the fixture aside
and place the mounting bracket within the markings and
outline the center slot. This will help determine where to screw
in the mounting bracket.
Note: If the fixture does not sufficiently cover the outlet box,
screw in the s emi-c ircular junction box covers on the back of
the fixture. (Fig. 2)
2. Screw the ceiling anchor into the center slot outline. Then align
the mounting bracket to the ceiling anchor and screw in the
mounting screw. Repeat with the second ceiling anchor 42
inches away. (Fig.1)
3. Pull the power supply wires out from the outlet box. Connect
the black supply wire to the black fixture wire using a wire
nut. Connect the white supply wire to the white fixture wire
using a wire nut. Connect the fixture ground wire and the
supply ground wire together using a wire nut. Wrap all wire
connections with electrical tape for a more secure connection.
(Fig. 4)
4. Place the fixture over the outlet box and slide the fixture so
that the mounting brackets snap into the bracket slots and is
secured flush against the ceiling. (Fig. 3)
5. On the side of the fixture, use the Wattage switch to
control power and the CCT switch to set light temperature.
(Fig. 7)
________________
DIMMING (Optional)
1. Pull wires from light fixture hole, the dimming wires will be
wrapped around the power supply wires. (Fig. 6) Connect
the purple and pink/grey fixture wires to corresponding
wires of the wall dimmer. (Fig. 5)
For up-to-date list of compatible dimmers, look up the item
number at www.envirolite-LED.com.
BLACK FIXTURE WIRE BLACK SUPPLY WIRE
WHITE FIXTURE WIRE WHITE SUPPLY WIRE
FIXTURE GROUND WIRE SUPPLY GROUND WIRE
Fig. 4
PURPLE FIXTURE WIRE PURPLE DIMMER WIRE
PINK/GREY FIXTURE WIRE PINK/GREY DIMMER WIRE
Fig. 5
Fig. 7
CTT SwitchWattage Switch
Fig. 3
Bracket Slot
Mounting Bracket
Fig. 1
Mounting Bracket
Center Slot