Installation Guide

INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions. Failure to do so may lead to
electrical shock or fire, which may cause injury or death.
________
CAUTION
WARNING – RISK OF FIRE: Turn off the main power at the circuit breaker before
installing the fixture, changing lamps, or performing other maintenance in order to
prevent possible shock.
_________
GENERAL
All electrical connections must be in accordance with local, and national electrical
codes.
Prior to installation it is important to follow the following guidelines:
A. Use only the type of tube light specified, with wattage not greater than
specified on the wattage label found on the fixture.
B. Remove all protective plastic film covering from the fixture.
___________________________
ASSEMBLY AND INSTALLATION
1. Remove the metal fixture pan from the
base housing by pinching together the
retainer clips. Install the retainer clips
by snapping them into the base
housing.
2. Connect the black supply wire to the
black fixture wire. Connect the white
supply wire to the white fixture wire.
Connect the ground supply wire to the
ground fixture wire.
3. Assemble the light fixture using the
clips. Make sure the acrylic diffuser is
seated correctly for a tight fit. Carefully
install the T-8 LED tubes.
4. Mount the metal clips to the surface
where light is to be placed. The
mounting clips should be spaced 31”
apart. Snap the fixture into the clips
making sure it is secure. Never drill
through the fixture to mount. This
will compromise the water tight
feature and could cause damage to
the fixture.
VAPOR TIGHT 2-LIGHT 4-FT LAMP
WIRED FOR T8 LED FLEX TUBES ID
MODEL Nº: EVVTS42T8
BLACK FIXTURE WIRE BLACK SUPPLY WIRE
WHITE FIXTURE WIRE WHITE SUPPLY WIRE
FIXTURE GROUND WIRE SUPPLY GROUND WIRE