Instructions / Assembly

INSTALLATION & ASSEMBLY:
1. Turn off the power at the circuit breaker box.
2. Remove the fixture from the packaging.
3. Rest the luminaire on the T-Bar of the ceiling
suspension system in the desired location (Fig.
1).
4. From above the ceiling, secure the Troffer to T-Bar
by bending built in hooks (#1) on all four corners
of the fixture (Fig. 2).
5. If local code requires, tie a wire to at least two of
the four hooks (#1) located near each corner of
the Troffer to a structural member of the ceiling
(Fig. 2).
6. Remove the access plate (#2) located on the
back of fixture. Locate the black and white fixture
supply wires (Fig. 2).
7. Remove one knockout in the access plate (#2)
(Fig. 3).
8. Thread the power supply wires through the
knockout hole in the access plate (#2).
9. Remove the access plate located on back of
fixture (#3) and locate the purple and grey
dimming wires (Fig. 3).
10. Remove one knockout in the access plate (#2)
(Fig. 3)
11. Thread the dimming wires through the knockout
hole in the access plate (#2).
12. Connect the black fixture wire to the black (+)
supply wire and connect the white fixture wire
to the white supply wire (-) using wire nuts.
Connect the supply ground wire to the fixture
ground wire using a wire nut (Fig. 4).
13. Connect the purple and grey fixture wires to
corresponding wires of the wall 0-10V dimmer
(Fig. 5).
14. Restore power at the circuit breaker box.
Page 4
Fig. 4
BLACK BLACK
WHITE WHITE
GROUND GROUND
FIXTURE WIRES SUPPLY WIRES
Fig. 5
PURPLE PURPLE
GREY GREY
FIXTURE WIRES DIMMER WIRES
Fig. 1
Fig. 2
Fig. 3