Installation Guide

PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):

GENERAL:

1. All electrical connections must be in accordance with local, and national electrical

codes.

2. Prior to installation it is important to follow the following guidelines:

A. Turn off the main power at the circuit breaker before installing the fixture, to

prevent possible shock.

B. Be sure that all wires were not damaged during installation and that there are no

rough or sharp edges in contact with the wires.

WARNING:

• Min 90°C supply conductors, Type IC, INHERENTLY PROTECTED.

• This product must be installed in accordance with the applicable installation

code by a person familiar with the construction and operation of the product and

the hazards involved.

• Blinking light of this thermally protected luminaire may indicate overheating.

• Vapor barrier must be suitable for 90°C.

• Suitable for damp locations.

1 Luminaire