Instructions / Assembly

3
Installation
1. Turn off the power at the circuit breaker
box. Remove the fixture (A) from the
packaging. Rest the fixture (A) on the T-
Bar of the ceiling suspension system in
the desired location.
2. From above the ceiling, secure the fixture
(A) to T-Bar by bending built in T-bar
clips on all four corners of the fixture (A).
If local code requires, tie a wire to at least
two of the four T-bar clips located near
each corner of the fixture (A) to a
structural member of the ceiling.
3. Remove the access plate located on end
of fixture (A) and locate the black fixture
wire and the white fixture wire. Remove
one knockout in the access plate.
Thread the power supply wires through
the knockout hole in the access plate.
Connect the black supply wire and the
white supply wire to the quick connector.
Connect the supply ground wire to the
fixture ground screw.
4. Remove the access plate located on end
of fixture (A) and locate the purple fixture
wire and the grey fixture wires.
5. If you decide not to connect a dimmer,
cap off the purple and grey fixture wires
individually with a wire nut.
6. If you decide to connect a dimmer,
remove one knockout in the access plate.
Thread the dimming wires through the
knockout hole in the access plate.
Connect the purple and grey fixture wires
to corresponding wires of the wall 0-10V
dimmer.
A
Fig. 1
A
T-bar
Clips
Fig. 2
A
Fig. 3
A
Fig. 4
NO DIMMING
PURPLE FIXTURE WIRE
GREY FIXTURE WIRE
DIMMING CONNECTIONS
PURPLE DIMMING PURPLE FIXTURE
WIRE WIRE
GREY DIMMING GREY FIXTURE
WIRE WIRE
Fig. 5