Instructions / Assembly

 Before starting installation of this fixture or removal of a previous fixture,
disconnect the power by turning off the circuit breaker or by removing the
fuse at the fuse box.
 Consult a qualified electrician if you have any electrical questions or need to
replace the driver.
 If you have any non-electrical questions about this fixture, please contact our
Customer Service Team at the phone number listed on the carton label.
 Min 90°C supply conductors, Type IC, INHERENTLY PROTECTED.
 Blinking light of this thermally protected fixture may indicate overheating.
 Vapor barrier must be suitable for 90°C.
 Suitable for damp locations.
Safety Information
FCC Notice
2
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiver antenna.
 Increase the separation between the equipment and receiver.
 Install the product onto on a circuit different from that to which the receiver is
connected.
 Consult with the dealer or an experienced radio/TV technician for help.
 CAUTION: Any changes made to the electronics circuit will void this
equipment’s compliance with Part 15 of the FCC Rules and should not be
operated.