Installation manual

Install the thermostat in the wall above the fan timer and install the
control box in the attic as per wiring diagram.
System Controls Kit
Timer
Thermostat
Powerash
& Relay Box
Remote module
Attach 5/8” poly water tube to water pump and place water pump in right
rear corner of water pan. Secure tube to side of media holder with wire ties
through adhesive anchor pads.
Check for proper ow of water through the media and back into water pan
by temporarily plugging pump into receptacle. Allow to run for several
minutes and make sure all water is returning into the water pan and that
there is no water dripping anywhere.
Unplug pump from receptacle, plug Appliance Module into receptacle
and then plug pump into bottom of Appliance Module. This remote
module will receive it’s on and o signals from the remote mounted
thermostat and control box.
Install the exterior housing. Hold in place, with (2) #10 x 5/8 self drilling
sheet metal screws on each side.
Install interior grill with white screws provided.
7
17.
18.
19.
20.
21.
22.
With water supply turned on, check for correct operation of oat valve.
Water should ll pan to approx. ¼” to ¾” below top of plastic overow tube.
Install media holder by attaching to mainframe with (4) #10 x 5/8 sheet
metal screws.
15.
16.