Owner`s manual

ManualsBrandsEnviro ManualsLawn and GardenQ2

2. Start the pilot by pressing the gas control knob and turning it to PILOT.

While holding the gas control knob in, press the piezo ignitor several

times until the pilot light starts. Hold the gas control knob in for 30

seconds. Check that the pilot has fully engulfed the thermocouple

assembly (see Figure 4).

3. Start the main burner by turning the gas control knob to ON and then

turn the rocker switch to ON. Check that all burner ports have ame.

4. Leak test all gas joints again.

aiR shutteR (VentuRi):

The air shutter adjustment lever is underneath the rebox (see Figure 5).

The air shutter allows the amount of air mixing with the incoming gas to be adjusted in order to

accommodate different climates and venting arrangements. Start the pilot and then the burner. Make

sure the pilot ame is burning normally and none of the burner ports are plugged. Let the replace burn

for roughly fteen minutes and then examine the ames for impingement or soot build up.

The ideal ame will be blue at the base and light orange above. The ames should be of medium height.

If the ames look like this, no venturi adjustment is needed. If the ames are fairly short and mostly

blue, the replace is getting too much

air. Therefore, the air shutter should

be closed (pushed it) slightly until the

correct ames are achieved. Flames

that are very orange, with tall, dark,

stringy tips, are not getting enough air.

Open the venturi until the ames clean

up. If the venturi is opened, or closed all

the way, and the correct ames cannot

be attained, turn off the gas and contact

the dealer.

Warning: Incorrect venturi adjustment

may lead to improper combustion, which

is a safety hazard. Contact the dealer if

there is any concern about the venturi

adjustment.

Figure 5. Air shutter adjustment lever

Thermopile

Thermocouple

Figure 4. Pilot Flame

Operating Instructions

PiLot Light:

1. Turn off the gas to the replace. If not recently done, remove the glass and let the unit air out

for at least ve (5) minutes to clear out any gas. Turn on gas to the heater. Leak test all joints

with soapy water. NEVER USE OPEN FLAME FOR LEAK TESTING.

Remote contRoLs (oPtionaL):

This replace can use an optional remote control or an optional cordless wall thermostat. If either of

these are to be used to control the replace for the majority of the time, leave the ON/OFF switch (on the

control panel) in the remote/thermostat position. Consult the instructions included with the remote/wall

thermostat for operation guidelines.

DATE: 7/28/2014

SHERWOOD INDUSTRIES LTD.

INTERNAL ASSEMBLY MANUAL

STATION:

THIS DRAWING IS THE PROPERTY OF SHERWOOD INDUSTRIES LTD. AND MAY NOT BE COPIED, REPRODUCED, OR OTHERWISE DISCLOSED WITHOUT THE PRIOR APPROVAL OF SHERWOOD INDUSTRIES LTD.

STEP:

1 of 1

SHEET:

PART NUMBER:

UPDATED: ----/--/--

STATION 1

STATION 3

STATION 4

STATION 2

Less Primary Air

More Primary Air

Note: Use the door tool to adjust

the venturi lever