Owner`s manual
12
Maintenance And Service
buRneR RemoVaL:
The burner may need to be removed for a few reasons, including cleaning under the burner or to be
replaced all together. Proceed only when the unit has completely cooled down.
Figure 10. Removing Burner
Step 1: Remove the glass door as shown in
the MaIntenance anD serVIce - Glass Door
reMoVal.
Step 2: Remove the log set and re grate
as shown in SeconDary InstallatIon - FIre
Grate anD loG set InstallaIon
Step 3: Pull the burner out of the venturi box
and out.
To re-install the burner follow steps 1-3 in
reverse. When placing the burner back in
the unit be sure to adjust the air shutter
back to the correct setting. Insure the front
and rear lengths of the burner tube are
parallel as it may have distorted with heat
over time. The ideal placement for the
burner tube is keeping it forward up
against the burner stand stops.
DATE: 7/18/2014
BY
SHERWOOD INDUSTRIES LTD.
INTERNAL ASSEMBLY MANUAL
THIS DRAWING IS THE PROPERTY OF SHERWOOD INDUSTRIES LTD. AND MAY NOT BE COPIED, REPRODUCED, OR OTHERWISE DISCLOSED WITHOUT THE PRIOR APPROVAL OF SHERWOOD INDUSTRIES LTD.
1 of 2
SHEET:
Q2 (DV33) - R04
STOVE:
UPDATED: ----/--/--
BY
--
REVISION:
0.0
DATE: 8/6/2014
BY
SHERWOOD INDUSTRIES LTD.
INTERNAL ASSEMBLY MANUAL
THIS DRAWING IS THE PROPERTY OF SHERWOOD INDUSTRIES LTD. AND MAY NOT BE COPIED, REPRODUCED, OR OTHERWISE DISCLOSED WITHOUT THE PRIOR APPROVAL OF SHERWOOD INDUSTRIES LTD.
1 of 1
SHEET:
STOVE:
UPDATED: ----/--/--
BY
--
REVISION:
0.0
Figure 11. Removing Burner
access DooR:
Step 1: Remove the burner as
shown in the MaIntenance anD
serVIce - Burner reMoVal.
Step 2: Remove the Upper Air
Diverter by removing (2) T-20
bolts. Remove the Lower Air
Diverter.
Step 3: Remove the right and
left burner stands by removing
(4) T-20 bolts.
Step 4: Remove the (16) T-20
bolts retaining the access door
as shown in Figure 11.
Step 5: After serviving assemble
in the reverse order.
There is an access door in the bottom on the rebox that is used for servicing components after the unit is
installed in a construction enclosure. Proceed only when the unit has completely cooled down.