Owner`s manual
11
Maintenance And Service
cLeaning DecoRatiVe suRfaces:
Painted and porcelain faces should be wiped with a damp cloth periodically. If a plated face has been
purchased, it should be unpacked/unwrapped carefully to avoid getting anything on the surface of the
nish, including cleaners, polish and nger prints. It is important to note that ngerprints and other
marks can leave a permanent stain on plated nishes. To avoid this, give the face a quick wipe with
denatured alcohol on a soft cloth BEFORE lighting the replace. Never clean the face when it is
hot. Do not use other cleaners as they may leave a residue, which can become permanently etched into
the surface.
gLass DooR RemoVaL:
The door needs to be removed for
sceduled cleaning and to install the
log set and various options. Use the
door tool to unhook the spring latch
door mechanism at the bottom
corners of the door frame. Once
detached pivot the door out and lift
up off the top spring latches.
To replace the glass door, simply
reverse the above procedure.
Warning: Do not touch or attempt
to remove the glass door if the
replace is not completely cold.
WARNING: Never operate the
replace with the glass door
removed.
Figure 8. Top Alightment Slots For Glass Door
Figure 9. Bottom Door Latch Mechanisms
Door Latch Mechanism
Top Spring
Latches
*Parts removed
for clarity*
DATE: 7/17/2014
BY
SHERWOOD INDUSTRIES LTD.
INTERNAL ASSEMBLY MANUAL
THIS DRAWING IS THE PROPERTY OF SHERWOOD INDUSTRIES LTD. AND MAY NOT BE COPIED, REPRODUCED, OR OTHERWISE DISCLOSED WITHOUT THE PRIOR APPROVAL OF SHERWOOD INDUSTRIES LTD.
1 of 2
SHEET:
Q2 (DV33) - R04
STOVE:
UPDATED: ----/--/--
BY
--
REVISION:
0.0
DATE: 7/17/2014
BY
SHERWOOD INDUSTRIES LTD.
INTERNAL ASSEMBLY MANUAL
THIS DRAWING IS THE PROPERTY OF SHERWOOD INDUSTRIES LTD. AND MAY NOT BE COPIED, REPRODUCED, OR OTHERWISE DISCLOSED WITHOUT THE PRIOR APPROVAL OF SHERWOOD INDUSTRIES LTD.
1 of 2
SHEET:
Q2 (DV33) - R04
STOVE:
UPDATED: ----/--/--
BY
--
REVISION:
0.0