Specifications

JOHNSON CONTROLS
8
FORM ET102.19-NOM1 (809)
Units without base rails must be lifted with slings. Place
slings at ends and joints of modules to prevent damage
to equipment (see Fig. 2).
Spreader bars should be used to prevent damage
to equipment. Avoid twisting or uneven lifting of
equipment. Do not lift equipment by coil connection
or headers. See submittal drawings.
If transporting units with forklift, forks must extend the
full width of unit to prevent damage to bottom of unit.
Always take special care when handling the blower
module. All fans are dynamically balanced. Rough
handling may cause bearing misalignment and/or shaft
damage.
STORAGE
To transfer equipment from truck to storage site, refer
to rigging details in gure and section on equipment
rigging for proper handling.
If a forklift is used, lift only from heavy
end of skid.
1. Do not stack unit modules or accessories during
storage. Stacking can cause damage or deforma-
tion.
2. If equipment is to be stored for more than two
weeks prior to installation, observe the following
precautions:
a. Choose a dry storage site that is reasonably
level and sturdy to prevent undue stress or
permanent damage to the equipment structure
or components. Do not store equipment on
vibrating surface. Damage to stationary bear-
ings can occur. Set equipment off ground if in
moisture prone areas.
b. Remove all shipped loose parts from job site
to minimize theft. Tag and store parts in a safe
place until needed.
FIG. 2 - LIFTING UNITS WITHOUT BASE RAILS