Owner`s manual

Routine Cleaning and Maintenance
EXHAUST VENT (Biannually)
This vent should be cleaned every year or after two tons of pellets. We recommend contacting your
dealer for professional cleaning. To clean the vent pipe, tap lightly on the pipe to dislodge any loose ash.
Open the bottom of the “T” to dump the ash, then vacuum as much of the ash out of the vent pipe as
possible.
FRESH AIR INTAKE (Biannually)
Inspect periodically to be sure that it is not clogged with any foreign materials.
BLOWER MECHANISMS (Annually)
Unplug the stove then open the right and left side panels to access the two blowers. Remove the two (2)
T-20 Torx screws on the back of the each panel. Pull the bottom of the panel out then slide the top of the
panel down off the tab. Vacuum all dust from motors. The blower motors’ has sealed bearings, DO NOT
lubricate this motor. Check gaskets and replace if needed.
PoSt SeaSon cLean-uP
Once you are finished using the pellet appliance for the season, unplug the stove for added electrical
protection. It is very important that the stove be cleaned and serviced as stated above.
CLEANING PAINTED SURFACES
Please clean painted surfaces with a soft damp cloth.
FIREBOX LINER
The paint on the Firebox Liner may peel. This is due to extreme conditions applied to the paint and is in
no way covered by warranty.
DOOR GLASS REPLACEMENT
It is recommended that your dealer replace the glass if broken. The door glass is made of high temperature
PYRO CERAMIC. To replace the glass, unscrew and remove the four (4) retainer nuts
7
/16” socket. Remove
the two (2) T-20 screws holding the inner door to the glass retainer. Remove the glass and any broken
pieces. High temperature fiberglass tape should be used around the glass in the same location as the
original fiberglass. Insert the glass into the retainer, screw the inner door to the retainer, install inner door
assembly into outer door and gently tighten nuts. The use of substitute materials is prohibited: Glass (9”
x 13” [229mm x 330mm]); EF-061.
12