Owner`s manual

Routine Cleaning and Maintenance

DOOR GLASS CLEANING (Weekly)

Cleaning of the glass must only be done when stove is cold. Open the door by lifting the handle. The glass

can be cleaned by wiping down the outside and inside of the glass with a dry soft cloth.

If the glass has build up that can not be removed with only the cloth, clean the glass using paper towel

and a gas appliance glass cleaner, this may be purchased through most dealers. If a gas appliance glass

cleaner is not available, use a damp paper towel dipped in y ash to clean the glass. After the glass has

been cleaned use the dry soft cloth to wipe down the outside and inside of the glass.

ASH PAN AND DOOR GASKETS (Weekly)

After extended use the gasketing may come loose. To repair this, glue the gasketing on using high-

temperature fiberglass gasket glue available from your local dealer. This is important to maintain an

airtight assembly.

ASH BOX (Weekly)

IMPORTANT: The unit must be OFF while the ash pan is removed.

The ash box is located behind the lower door (see Figure 10). To remove the ash box, lift the latch on the

right, open the ash box door, and lift it out.

Dump the ashes into a metal container stored away from combustibles. Monitor the ash level every week.

Remember that different pellet fuels will have different ash contents. Ash content is a good indication

of fuel efficiency and quality. Refer to “

saFety

Warnings and recOmmendatiOns” for disposal

of ashes. Vacuum the inside of the ash pan

compartment inside the pedestal including the

hole at the top back of the compartment.

Insert the ash box fully and close ash box

door.

DO NOT PLACE UNBURNED OR RAW

PELLET FUEL IN ASH PAN.

EXHAUST PASSAGES (Biannually)

• Open the firebox door by lifting the handle.

• Remove the burn pot and burn pot liner;

clean both.

• Using a ⅜” socket, remove the two (2) bolts

that hold the firebox liner in place. Vacuum

the firebox and firebox liner thoroughly.

• Open the ash box door; remove the ash box

and cleanout the cavity.

• Clean out the transition box to the

combustion blower (located behind the ash

box)

• Lubricate all screws with penetrating oil.

• Re-install the ash box, firebox liner, burn

pot, and burn pot liner

• Close the firebox and ash pan doors and

secure.

Figure 10: Maxx Exhaust Passages.