- Sherwood Industries Ltd. Indoor Fireplace User Manual

Install 2 spring spacers around the flex pipe. Slide the horizontal section of pipe

over the flexible liner and install through the wall thimble, ensure that this

portion of pipe slides onto the vent termination cap. Slide the inside finished

collar over the horizontal section of pipe and secure to wall using the screws

provided. Slide the 90° elbow over the flex pipe. Stretch the flex liner to a

length long enough to ensure the flex liner can be easily connected to the flue

outlet of the appliance. Install the remaining spring spacers over the flexible

liner and install the vertical section of pipe.(DO NOT SLIP THESE SECTIONS

OF PIPE TOGETHER, YOU WILL REQUIRE SOME MOVEMENT IN THESE

PIPE SECTIONS IN ORDER TO SECURE THE FLEX PIPE TO THE FLUE

OUTLET ON THE APPLIANCE.)

Place a bead of high temperature silicone on the flue pipe and slide flex liner

over collar, secure the flex liner with 3 sheet metal screws evenly spaced.

Align all straight sections of pipe, slipping all joints together and installing 3

sheet metal screws evenly spaced.

A small can of touch up paint has been supplied with this kit. Lightly touch up

any scratches that might have accord during the installation process.

Install brass decorative rings around each joint making sure this decorative ring

covers the sheet metal screws which secure each section of pipe together and

secure to vent pipe in the slotted tab on the backside of the pipe so that the

fastener would not be easily seen.

Secure the horizontal section of pipe to the inside finished collar by installing a

screw in the tab on the inside finished collar. (THIS WILL PREVENT THE PIPE FROM BEING DISCONNECTED AT THE

VENT TERMINAL.)

SPRING

SPACERS

Light the appliance and ensure proper operation.

WALL

FRAMING

HORIZONTAL WALL

TERMINATION

WALL THIMBLE

FIRE STOP

DECORATIVE

BRASS RINGS

INSIDE

FINISHED

COLLAR

EXHAUST

4” FLEX

PIPE

COMBUSTION

AIR

6 5/8” OUTER

PIPE