Operating instructions
30
C-CAst CerAmiC BAFFle instAllAtion:
Left Ceramic Baffle
Right Ceramic Baffle
Figure 21: Installation of C-Cast Ceramic Bafe.
Installation
FAn wiring diAgrAms:
This appliance, when installed, must be electrically connected and grounded in accordance with local
codes or in the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part
1, SAFETY STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL CODE ANSI
/ NFPA 70 in the USA.
CAUTION Label all wires prior to disconnection when servicing controls. Wiring errors
can cause improper and dangerous operation. Verify proper operation after servicing.
DO NOT oil the fan bearings.
DO NOT cut or remove the grounding prong from the plug.
DO NOT route the power cord beneath the heater.
WARNING: This appliance is equipped with a three-prong (grounding) plug for your protection against
shock hazard and should be plugged into a properly grounded three-prong receptacle.
1. Slide the right C-Cast Ceramic Bafe in
over the secondary air tubes at the top
of the rebox. The tab must be on the
top and pointing towards the center
and the smooth side is to face down.
2. Hook the outside edge of the bafe
over the top of the secondary air
chamber. This will make room to for the
installation of the left C-Cast Ceramic
Bafe.
3. Slide the left C-Cast Ceramic Bafe in
over the secondary air tubes. The tab
must be on the bottom and pointing
towards the center and the smooth side
is to face down.
4. Pull the bafes together in the middle
so the right tab rests on top of the left
tab. Ensure the bafes are ush with
the back and both sides of the rebox.