- Sherwood Indoor Electric Fireplace Owner's Manual

Operating Instructions
FOR YOUR SAFETY READ COMPLETELY BEFORE OPERATING.
LIGHTING INSTRUCTIONS:
6
CAUTION:
Hot while operating. Do not touch. Keep children, clothing,
furnit ure, gasoline or other flammable vapors away.
FOR YOUR SAFETY: Do not operate this fireplace with the glass removed, cracked or broken.
Replacement of this glass should be done by a licensed or qualified person! This appliance needs fresh
air for safe operation and must be installed with provisio ns for combustion and ventilation air.
See installation and operating instructions manual. Keep burner and control compartment clean .
Improper installation, adjustment, alteration , service or maintenance can cause property
damage, personal injury, or loss of life. Refer to owners manual. Installation and service must be
performed by qualified installer, service agency or the gas supplier.
WARNING:
TO TURN OFF GAS TO APPLIANCE
1.
2.
Fli p burn er switch to “OFF”
Turn the gasco ntrol knob c lockwise to th e “OF F”
po sition
3 . Turn off all electrical po wer to the ap pliance if service i s to
be performe d.
ACLIE -1
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIO NS EXACTLY, A FIREO R EXPLOSION MAY RESULT CAUSING
PROP ERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
A)
B) BEFORE LIGHTING
WHAT TO DO IF YOU SMELL GAS:
This applianc e is e quippe d with a pilot, which mus t be lit by
hand
smell all around the appliance area
f or gas
Do not try t o light any a pplian ce. Do not touch a ny electrical
switch:
Immediately call your gas sup plier f rom a neighbors p hone.
Follo w
b y following these instructions e xactly.
and n ext to the floor because some gas is heavi er
t han air and will se ttle on the floor.
do not use any phone in you r building.
the gas suppliers instr uctions.
If you cannot re ach your gas supp lier, call the fire departm ent.
Use only your ha nd to p ushin or tu rn the gas co ntrol knob,
Call a qual ified service techn ician. Force or
Do n ot use thisa pplian ce if any part has b een u nder water.
C)
D)
Neve r use tools. If the k nob will not push in or turn by
hand , do n ot try to rep air it.
attempte d
repair may result in a fire or explosion.
Immediately call a qualified service technician to inspe ct
the a ppliance an d to replace any part of t he con trol system
and any ga s con trol which ha s been unde r water.
LIGHTING INSTRUCTIONS
1.
2.
3.
4.
5.
STOP! Read th e safe ty information above on th is labe l.
Turn off all elec trical power t o this applian ce.
Turn off t he gas contr ol knob clockwise to the off
position.
Open door. Wa it five (5) minutes to clear out any gas.
Cl ose do or.
If you do not smell gas go to the next ste p
Fin d pilo t-locate d to th e righ t behin d the side log. Turn
the gas control
If y ou sme ll gas, includ ing near the floor ,
STOP! Follow “ B” inthe above safety inf ormation.
kn ob cou nter-clockwise to “PILO T”.
Push the gas co ntrol in
ful ly and hold, Keep knob
depressed for a bout 30 seco nds after
pilot is lit. Release kno b. If p ilot goes out,
rep eat st eps 4 t hrough 5.
: this gas valve ha s a lockout device, whichwill
n ot allow
stop and imme diately
I f the pilot does not stay lit after several tries, turn the gas
control
Turn the gas control k nob counter clockwise t o the
“ON”
Turn on the ele ctrical power to the unit.
WARNING
6.
7.
the pilot burner to be relit until the ther mocouple
h as cooled. If the knob does not po p up when released,
call yo ur service tec hnician or gas
supplier.
knob to “OFF” and call your service technician or
g as supplier.
position. Flip the burner switch to
“ON” THEN TURN THE “HI/LOW” knob to the desired setting.
Figure 2. Lighting instruction label.