Specifications

INTRODUCTION

Thank you for purchasing the Saranac pellet stove. The Saranac is available as an insert

or a freestanding stove. The Saranac has been tested and listed for installation in

residential, mobile homes and alcove installations.

This heater has been certified to ASTM E1509-04 Standard Specification for Room

Heaters, Pellet Fuel-Burning Type.

The performance of you pellet stove can be affected by the type of pellet fuel burnt in the

appliance. It is important to use only pellet fuel that is dry and free from dirt or other

impurities.

The Pellet Fuel Industry has established standards for wood pellet manufacturers. It is

recommended that the fuel used in this appliance meet or exceed the following

specifications:

Fines (fine particles)…….1% maximum through a 1/8" screen

Bulk Density…………….minimum 40 lbs per cubic foot

Size……………………...maximum 3/8" diameter by 1-1/2" long

Ash Content……………..1% maximum (Premium grade)

……………..3% maximum (Standard grade)

Moisture Content………..8% maximum

Heat Content…………….minimum 8,200 btu/hr

It is important to note that the ash content of the fuel (and frequency of operation)

determine the frequency of cleaning required for your unit. A high ash fuel may result in

your unit having to be cleaned daily while a low ash content fuel may permit a longer

time between cleaning.

Occasionally impurities in the fuel will cause a hard mass build up in the burn pot. This

build up may block the air flow through the burn pot affecting the performance of your

unit. Check the burn pot daily for any blockage. If necessary remove the burn pot liner

(once unit has cooled) and clean the liner and the burn pot.

Since Inca Metal has no control over the quality of pellet fuel used in this unit they

assume no responsibility for the end users choice in wood pellets.

Caution: Be sure to store the pellet fuel a minimum of 3' (0.9 m) away from the pellet

stove.

Please note that the rating label may be found on the inside of the hopper lid for the

freestanding unit and on the hopper cover for the insert.