Fire Pit User Manual

3. DECIDING WHERE TO LOCATE YOUR STOVE

FREESTANDING:

• Locate the stove in a large and open room that is

centrally located in the house. This will optimize heat

circulation and comfort.

• The stove should be located out of traffic, away from

furniture and draperies and should have sufficient

access for its safe operation and maintenance.

• The flow of convection air can not be blocked

• The stove can be installed on any combustible flat

surface providing that it is installed on a metal or wood

panel extending the full width and depth of the

appliance.

• Check the stove and flue system clearance

requirements. Locate a position where the flue system

of the stove can be properly installed without damaging

the integrity of the building. e.g. cutting through a wall or

ceiling joist.

• Locate the stove where it can be accessed by a gas

supply line.

• Note: If the stove is equipped with the optional

convection fan, the electrical cord is only 8 ft. (2.4 m)

long.

FIREPLACE INSERT

• The fireplace insert model can only be located in an existing wood burning steel or masonry fireplace. The existing chimney

must be lined using a Simpson Dura Vent sealed co-linear vent system using the Envirogas kit 828-135 (DV insert / co-linear

adapter).

4. ASSEMBLY INSTRUCTIONS

INSTALLATION

Remove the packaging from the appliance, pedestal or surround panels and burner controls, check to make sure there is no

damage. Carefully check the glass door. Do not use the unit if it is damaged. In the event damage is found, please report it to

both the courier and your dealer as soon as possible.

• Open the two hinged side panels, open the door by undoing the bolt, located on the right side (1/2 inch wrench).

• Remove the log and ember set from the firebox.

• Remove the two hold down clamps that attach the stove to its pallet ( #2 Robertson screwdriver ). These are hooked through

the square openings immediately behind the side panels on each side of the unit.

BOTTOM VIEW

FREESTANDING

• Place the stove on its back, on the pallet.

• Back off the 4 screws ( 5/16 hex head located on the base) 2 turns. Place the

pedestal so that the screws in the base of the stove engage the keyholes in the

pedestal. Check to see that all screws are locked, then tighten with a 5/16 socket

wrench.

• Return unit to upright position. Complete the installation. Install the burner

controls, log set, embers and optional fan kit as per the instructions in the upcoming

sections.

PEDESTAL MOUNTING SCREWS