Fire Pit User Manual

2. DIMENSIONS AND CLEARANCES TO COMBUSTIBLES

FIREPLACE INSERT: The stove can only be installed in a solid fuel burning fireplace .

Mantle pillar to stove 10”

Stove top to 8” wide mantle 12”

Minimum firebox size W 26” x H 20” x D 20”

(NOTE; standard size shown – optional 33”H x 46”W available)

FREESTANDING:

Side wall to stove 10"

Rear wall to stove 4"

Combustible to stove Top 22"

Floor to stove 0"

Corner clearance 2"

Alcove depth 48"

Maintain sufficient clearances for service and maintenance

FIREPLACE INSERT / WITH ZERO CLEARANCE KIT ( Part # 828- 134 )

After deciding where to locate the fireplace insert you must frame an opening to except the Zero Clearance Box to reduce the clearance to

combustibles. The framing dimensions are as follows; 32 1/4” wide, 29 3/8” high and a depth of 14 3/4”.

The header at the top front of the opening must be a 2x4 on edge or a cut out in the 2x4 to maintain clearances to combustibles to the vent

pipe. A minimum of 1 1/2” clearance must be maintained to the vent pipe.

Before you install the Zero

Clearance Box you must

determine the finished hearth

height.(including tiles, subfloor, etc.)

The bottom of the box must be the

same height as the finished

hearth height.