Unit installation

MAC 10
®
LEDC
4x4 Fan Filter Unit
3Innovators in Clean Air Technology | www.envirco.com | Operation & Maintenance
Installation & Service Manual
■ Critical Operation Conditions of the MAC 10
1. Touching of the HEPA lter will damage it, voiding the warranty on the lter. The screen is only to protect against an
accidental ‘touch’ of the lter. Never place a hand or tool on the lter. Never lie lter face at down on a surface always
have lter on its side to protect from damage.
2. Prior to powering the unit, verify that the unit has been wired into the correct voltage. The serial number label on the top
of the Mac 10 unit has the required voltage.
3. To insure you order the proper replacement parts or complete MAC 10 unit, record the part number and serial number.
This information is located on the serial number label, located adjacent to the electrical box. If you can’t locate the Sales
Order Number, please contact Envirco for this information.
■ Part Numbers Covered by this Manual
11185-XXX MAC 10 LEDC 4x4 Standard Filter
11233-XXX MAC 10 LEDC 4x4 RSR Filter
11233-Z XXX MAC 10 LEDC 4x4 RSRE Filter
Note: A ‘Z’ in the part number indicates that the unit is special.
This may indicate a size change from standard or a special lter.
Please contact the factory for part numbers if this is the situation.
Units come set in manual mode from
the factory. Please review installation
requirements and set up with your end user
(See page 8 for complete set up instructions).