User's Manual

EZBee series Manual / Ver. 1.0
64
Enter “
““
“ AT+IOD@1?
AT+IOD@1?AT+IOD@1?
AT+IOD@1? ”
””
” command on a coordinator and read GPIO
input/ output status.
When the command is completed successfully, the response message,
“
““
“$IOD@1=00
$IOD@1=00$IOD@1=00
$IOD@1=00”
””
” is displayed, which means all GPIO of a router is set as
inputs.
To read GPIO input status value of a router module, enter “
““
“AT+IO@1?
AT+IO@1?AT+IO@1?
AT+IO@1?”
””
”
on a coordinator terminal. If the command is completed successfully, the
response message such as “
““
“$IO@1=BF
$IO@1=BF$IO@1=BF
$IO@1=BF”
””
” is outputted. It means the input
value of DIO6 is 0 and the others of GPIO are 1.