User's Manual

EZBee series Manual / Ver. 1.0
60
5.
5. 5.
5. Testing message transmission in
Testing message transmission inTesting message transmission in
Testing message transmission in Bypass
Bypass Bypass
Bypass mode
modemode
mode
1) Enter “
““
“ATD 1
ATD 1ATD 1
ATD 1”
””
” command on a coordinator terminal, and “
““
“ATD 0
ATD 0ATD 0
ATD 0”
””
” on
a router terminal.
2) Type any keys on one terminal, and verify successful data
transmission on the other terminal.
3) To end Bypass mode, enter “
““
“+++
++++++
+++”
””
” on each terminals.
6.
6. 6.
6. Testing Input/output function of
Testing Input/output function of Testing Input/output function of
Testing Input/output function of EZBee
EZBeeEZBee
EZBee M100
M100M100
M100
EZBee M100 supports total 8 ports of GPIO from DIO0 through DIO7
which are set or controlled by a local or remote modem of EZBee.
First, enter “
““
“AT+IOD?
AT+IOD?AT+IOD?
AT+IOD?”
””
” command on a coordinator terminal to check
the I/ O directions of local EZBee M100. In this example, the return value
shows “
““
“00
0000
00”
””
”, it means all I/ O ports are assigned as input ports.