User's Manual

EZBee series Manual / Ver. 1.0
55
3.
3. 3.
3. Joining the
Joining the Joining the
Joining the PAN
PANPAN
PAN
After running another terminal emulator, set the serial port and EZBee
M100 as shown in 1 and 2 steps above.
Then, type the AT commands related to a module ID, PAN ID and
channel number. In this moment, the module ID can be any number
except ‘ 0’. However, a PAN ID and channel number should be same
numbers as coordinator setting for joining in the PAN established already.
Finally type “
““
“AT&PS
AT&PSAT&PS
AT&PS”
””
” for a new EZBee M100 to join in the PAN.
If the EZBee M100 is joined in the PAN successfully,
“
““
“$NWK=ROUTER
$NWK=ROUTER$NWK=ROUTER
$NWK=ROUTER,<SADDR>”
””
” message is displayed.
It means the EZBee M100 is assigned as a router in the PAN, and a
short- address of this EZBee router is assigned as <SADDR> by a