User's Manual

EZBee series Manual / Ver. 1.0
33
When the group ID command for a remote modem is conducted
successfully, the following return message is returned.
Message Description
$GID@
<DstID>
=
<GroupID> Group ID < GroupID> setting
in a remote modem <DstID>
7.2.5
7.2.57.2.5
7.2.5 Receiver ID setting for Bypass mode
Receiver ID setting for Bypass modeReceiver ID setting for Bypass mode
Receiver ID setting for Bypass mode
The EZBee formats supports the bypass mode communication which
all data are collected by a specified modem as if all modem in a network is
wired to a specified modem.
The receiver modem should be assigned before starting the bypass
mode communication using following AT commands.
Command Parameter Result Description
AT+DST?
None
0~253
Check the ID of a receiver modem
assigned already within the modem
AT+DST= 0~253
OK
Set the ID of a receiver modem onto
the modem
ERROR
7.2.6
7.2.67.2.6
7.2.6 Automatic start mode setting
Automatic start mode settingAutomatic start mode setting
Automatic start mode setting
When a modem is reset, the PAN can be started or joined
automatically by using following AT commands. The commands are
effective in the ASCII mode communication only.