User's Manual

EZBee series Manual / Ver. 1.0
24
6. AT
AT AT
AT Command
CommandCommand
Command
The EZBee formats support various AT commands for controlling the
modem. Customers can configure the desired characteristics of a
specific network using the rich AT commands
6.1 Reference table for
6.1 Reference table for 6.1 Reference table for
6.1 Reference table for AT
AT AT
AT Commands
CommandsCommands
Commands
AT
command
Category Description Parameter Default
D
System
Change modem mode to
‘BYPASS’ mode
<Modem ID>
B
System
Change modem mode to ‘EBI’
mode
None
Z
System
Modem reset
None
NZ
System
Modem reset with erase
network states
None
V
System
Show modem version
None
S
System
Show modem status
None
+SPI
Set
Set/Get RS-232C interface
configuration
?
38400/
HW
flow
=<baud>,<flow>
+CH
Set Get /Set frequency channel
?
11
=<11~26>
+DST
Set
Get/ Set default destination ID
for binary mode
?
0
=<Modem ID>
+E
Set
Serial echo on/off
0 / 1 1
+EA
Set Get 64-bit extended address ?
+ID
Set Set/Get modem ID ? 23