User's Manual

make a call or transfer music via car audio system.
13) FM Frequency Selection Mode
The product has 7 pre-programmed frequencies. You can select one of them following these
steps:
a. Check if the car kit is in the Pairing Mode.
b. When FM transmission mode is not active, press and hold down the FM/TTS button
for 2 seconds. Release the FM/TTS button when you hear a beep.
c. FM status icon blinks every 1 second indicating that FM Frequency Selection Mode
is on, and the current frequency is announced. Select the desired frequency by
pressing the Volume Up and Volume Down button.
d. To exit Selection mode, press and hold down the FM/TTS button for 2 seconds.
e. You can check the frequency fixed by voice announcing.
f. If you cannot find the desired frequency, see 14) Scanning an FM Frequency
Note: To end the FM Frequency Selection Mode, repeat the above steps.
14) Scanning an FM Frequency
When pre-programmed frequency is crossed or the frequency is pre-used by the others, you
can scan the available frequencies following these steps:.
a. Check if the car kit is in the Pairing Mode
b. When FM transmission mode is not active, press and hold down the FM/TTS button
for 4 seconds. Release the FM/TTS button when you hear the message “Searching”.
c. Check if the Connection LED and Call Status LED are lit on.
d. When the scanning is finished, the selected frequency is announced.
e. If you don’t want to use the selected frequency, see 13) FM Frequency Selection
Mode.
Note: You do not need to scan again if you use the frequency in the same area.
15) Caller ID
When there is an incoming call, the caller’s ID number is displayed on the car audio
system LCD.
Note: Caller ID function is car audio system dependant. (RDS feature should be available
in order to use this function.)