User's Manual

2. Charge your BHF5000 device
Make sure that your speakerphone is fully charged before you start using it.
Use the USB cable to con nect BHF5000 to the car ch arger. Plug the ca r charger into your
car’s power outlet. The status light will light up red while charging. When fully charged the
status light green on.
Note)
A fully charged battery prior to first use is recommended.
A full charge is approximately two and a half hours.
Note)
When the battery only has enough charge for about 1- 2 hours of talk time, the flashing red
battery LED light indicator comes on (“Battery level low” is announced)
3. Pair your BHF5000 with your mobile phone
Prior to using the speakerphone for the first time , you must pair it with a Bluetooth-e nabled
mobile phone. Specific pairing steps may vary with dif ferent mobile phones. Please refer to
your mobile phone`s user`s manual for further information. The general pairing steps are as
follows:
1) Activate Bluetooth® on your mobile phone
2) Ensure that BHF-5000 is turned on, switch to pairing mode by holding onto the “MFB”
button until you hear “P air mode”. The co nnection and Call LED light sill blink
simultaneously in pairing mode.
(Put the speakerphone in pairing mode)
3) Set your mobile phone to ‘search’ for the BHF5000
4) Select “BHF 5000” from the search results on your mobile phone.
5) When prompted for the passkey, enter “0000”.
Note)
The first time you turn your BHF5000 on it will immediately go into pairing mode.
6) When the BHF50 00 is paired, the Bluetooth® Icon turns bl ue. Your mobile phone
might display a confirmation message, also.
Manual pairing mode
If you wish to use the sp eakerphone with a di fferent phone, or if the p airing process wa s
interrupted, you can manually set the speakerphone to pairing mode.
Turn the speakerphone on. Press and hold the MFB button for approximately 5 seconds until
speak “Pair mode”