User's Manual

3-Way Power Supply with Plugs
(Con’t)
3-Way Power Supply with Plugs
(Con’t)
Figure 6b: Attaching a plug
Figure 6c: Detaching a Plug
Figure 6d: Connecting the Power Cable to the
Connecting the
Power Cable
Disconnecting
the Power Cable
FLEX 3
FLEX 3
The DryBuddyFLEX 3 is designed in USA. Assembled in China.
©2017 by Enuresis Solutions, LLC
• The DryBuddy alarm is intended for use as a bed-wetting
and enuresis alarm by children of age ve and older, or as
recommended by a medical authority. It can be used by
older patients as a urine sensor and wetness alarm and as
an incontinence alarm.
• The DryBuddy system is a medical device and should be
treated as such. Do not use roughly or damage.
• Do not use as a potty training aid for babies, toddlers and
young children.
• Make certain that no parts of the DryBuddy or sensor are
put in the mouth for any reason as this could cause choking
or other harm.
• Observe all sanitary precautions to keep the sensor clean
and the alarm parts clean and dry.
• Do not use the sensor for more than one user without
thorough cleaning.
• Do not strike the magnetic sensor or cap on hard surfaces
or make them hot as this can reduce magnetism.
• The DryBuddy system is designed to sense urine or salty
water. It is less eective in sensing plain water.
Caution when Using the DryBuddy1 System
Important Safety Instructions for Transceiver
Read these instructions carefully. Keep these instructions for later reference.
All cautions and warnings should be followed.
The rating of the equipment is input & output: The socket-outlet shall be installed near the
equipment and shall be easily accessible.
The equipment shall be used at maximum 40°C ambient temperature.
Do not open the equipment to reduce the risk of electrical shock. For safety reasons it is
only allowed to be opened by qualied service personnel.
Protect equipment from humidity.
Equipment has to be protected from objects falling through or liquids dripping through the
openings. This could cause a re or eletrical shock.
Disconnect equipment from power supply before cleaning. Do not use any liquid or
aerosol cleaner. Use only moistured cloth.
If the equipment is not used for long time, disconnect the equipment from power supply
to avoid being damaged by voltage peaks or lightning strike.
If one of the following situations arise, equipment has to be checked by qualied service
personnel
• Plug is damaged.
• Liquid has penetrated into the equipment.
• Equipment has been exposed to humidity.
• Equipment has obvious sign of breakage.
• Equipment does not work well or you cannot get it working according to user’s manual.
The equipment shall not be exposed to dripping or splashing and no object lled with
liquids, such as vases, shall be placed on the equipment.
For indoor use only.
Polarity of DC output Jack: Center is anode.
The appliance is designed to supply information technology equipment and similar
electrical appliances.
This product must not be disposed together with the domestic waste. This product has
to be disposed at an authorized place for recycling of electrical and electronic appliances.
By collecting and recycling waste, you help save natural resources, and make sure the
product is disposed in an environmental friendly and healthy way.
FCC Warning
DryBuddyFlex 3 System
The grantee is not responsible for any changes or modications not
expressly approved by the party responsible for compliance. Such
modications could void the user’s authority to operate the equipment.
This equipment has been tested to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable portection against harmful interference
in a residential installation.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.