User Manual

ODE MK3 (70407)
Visit the ENTTEC website for the latest version.

USER MANUAL
10 |
ID: 5946689
Document updated
December 2022
 Input sACN Priority: sACN Priorities range from 1 to 200, where 200 has the highest priority. If you have
two streams on the same Universe, but one has the default priority of 100 and the other has a priority
of 150, the second stream will override the first.

Output Merging: When enabled, this can allow the merging for two DMX sources from different IP address
whilst sending on the same Universe in either a LTP (Latest Takes Precedence) or HTP (Highest Takes
Precedence) merge. More information can be found in the Functional Features section of this document.
Save settings: All changes must be saved to take effect. The ODE MK3 takes up-to 10 seconds to save.
Factory Default: Factory resetting the ODE MK3 results in the following:
 Resets the device name to defaults
 Enables DHCP
 Static IP 192.168.0.10 / Netmask 255.255.255.0
 Output protocol is set to Art-Net
 Merging is disabled
 Port 1 Universe 0
 Port 2 Universe 1
 RDM enabled
Restart Now: Please allow up-to 10 seconds for the device to reboot. When the web interface page refreshes
the ODE MK3 is ready.
Network Stats
The Network Stats tab is designed to provide an
overview of the network data. This is broken down
into Ethernet-DMX protocols statistics which can be
located within the tabs.
The Summary provides details regarding total, poll,
data or sync packets depending on the protocol.
Art-Net Statistics also provide a breakdown of Art-
Net DMX packets sent and received. As well as a
breakdown of RDM over Art-Net packets including
packet sent and received, Subdevice and TOD
Control/Request packets.
Update Firmware
When selecting the Update Firmware tab, the ODE
MK3 will stop outputting and the web interface boots
into the Update Firmware mode. It may take a while
depending on the network setting. An error message
is expected as the webpage is temporary unavailable
in boot mode.
This mode will display basic information regarding
the device including current Firmware Version, Mac
Address and IP address information.
The latest firmware can be downloaded from
www.enttec.com. Use the Browse button to access in
your computer for the latest ODE MK3 firmware file
which has a .bin extension.
Next click on the Update Firmware button to begin updating.