User manual

-9--8-
Table 1 :
Table 2 (Installer Setup) :
Basic Tools Detail :
To check the voltage of the monitor,
note that the monitor must be online.
Item Submenu
1. Installer Setup
1. ID Code [0]
2. Unlock Timing [05]
3. Unlock Output [0]
4. Card Memory [0]
5. Doorplate Mode
6. Audio Opons ...
7. Parameters ...
8. Installer Code ...
9. Default ...
2. Setup
1. Language [1]
2. Tone Select [03]
3. Tone Volume [08]
4. Unlock Code [1111]
5. Display Mode
6. Clock ...
7. Setup Code ...
8. About ...
9. Default ...
3. Card Manage
1. Add Card ...
2. Delete By Card
3. Delete By M.code
4. Cards Informaon
5. Format
4. Online Monitors
To search the online monitors, input
the monitor code number to search
5. Online Devices
To search the online door staons.
Max.4 door staon can be searched
6. Voltage Measure
Item Factory SetDescripon
ID Code [0] Single
[66666666]
0
0
0
[05]
5 Seconds
If only one door staon is installed in this building,
set to 0 ;
If mul door staons are installed, primary door
staon must be set to 0, and other slave door
staons must be set from 1 to 3. Note that max.
4 door staons are available in one building
Unlock Timing
Unlock Output
Card Manage
Doorplate Mode
[0]
Auto mode
Audio Opons ...
Parameters ...
Installer Code ...
Default ...
To set the me that how long the door keeps open
when door is released. Range from 01 to 99 seconds.
To set the unlock mode to match the corresponding
lock.Range from 0 to 1.
0: Power-on-to-Unlock Mode(Normally Open Mode)
1: Power-off-to-Unlock Mode(Normally Closed Mode)
To set the card locaon.If set to 0,the card is saved
in door staon.If set to 1, the card is saved in DT-IPC
To set the calling mode. If set to 0,it's the auto mode,
that means the calling will be acvated directly aer
inpung 2 digits code.If set to 1, it's the manual
mode,that means you should press "#" buon to
acvate the calling aer inpung the code.
To set talking mode, when cung voice or mixed
voice appears, set to 1.
DS-IM talking:set the vioce matching between
DoorStaon and Indoor Monitor
DS-NT talking:set the vioce matching between Door
Staon and Guard Unit
To show the parameters,please refer to table 2.1
To change door staon administrator code
Note this operaon is irreversible. Once restore is
acvated, all parameters will return to factory default
seng except the informaon of access card.