User manual

-17--16-
11. Change Door Staon Language:
It's convenient to change the user interface for DMR18.Just put the config files to the SD
card and by means of the digital keypad of door staon,only 30 seconds is needed to
update.
Step 2:
If door staon runs as Debug State, you can press “1#” to acvate Tools Menu, select “2”
to enter setup page,then select 1 item.If it runs as Normal State, follow these steps:
Delete user cards:
Registered User Cards/Key Fobs can be deleted from the Door staon,once doing the delete
operaon,the card/key fobs can not open the door anymore. They can also be re-registered
again to become a valid User Card/User Key Fob. There are two ways to delete User Cards/
User Key Fobs:
1. Delete by card: show the unwanted card(s) when the Door staon is in Delete Card Mode
2. Delete by room number: delete all the registered User Cards related to that room No.
Delete By Card:
In Debug State , Press [1 #] --> [3]
Card Manage -->[2] Delete By Card
to enter Delete by Card page.as
shown on the right, then show the
cards you want to delete one by one.
Delete by Room Number:
In Debug State , Press [1 #] --> [3]
Card Manage -->[3] Delete By M.Code
to enter Delete by M.Code page.as
shown on the right, then Input the
Room Code, press “#” to confirm; all
associated cards will be deleted.
Card informaon:
Enter Card Informaon page, and the
screen will display the authorized User
Cards count, and card read access
events count.
Format:
Enter Card Format page, a password
will be asked,input 8 digits installer
password (66666666 by default),then
press" #" key to save,format operaon
is acvated.all card informaon will be
cleared.
Step 1: Insert the SD card which is
contained config files into the SD card slot
where is at the back of the door staon.
Refer to the right diagram.
1. AddCard ...
* Back # Save
Please Input Room Code
[ - - ]
1. AddCard ...
* Back # Save
Show the card
[ 0 1 ]
1. AddCard ...
* Back # Save
[ 0 1 ]
C a r d numbs :
1 5 9 7 7 1 3 1
Show The Card
U
s
e
r
C
a
r
d
2. Del e t e B y C ard ...
* Back # Save
Show The Card
2. Del e t e B y C ard ...
* Back # Save
U
s
e
r
C
a
r
d
C a r d numbs:
1 5 9 7 7 1 3 1
Show The Card
3. Del e t e B y M.c o d e
* Back # Save
Please Input Room Code
[ - - ]
3. Del e t e B y M.cod e
* Back # Save
U p d a t e d
[ 0 1 ]
Enter Add Card menu,
and Room Code is asked.
Input Room Code Read the card to be
authorized
4. Car ds Informatio n
* Back # Save
Card Count: 1000
5. F ormat
* Back # Save
Please Input Password
[ - - - - - - - - ]
L1
T/R -
CN-LK
T/R+
J/KMB JP-LK
Bus
Insert SD card
SD Card Slot
EB+ EB- N.O LK+ LK-
+12V
L2
12
3
12
3