User's Manual
Table Of Contents
- Cover
- Contents
- 1 Welcome to the Card Personalization System
- 2 Installation Requirements
- 3 Install the System
- 4 Using the System
- 5 Card Design
- 6 System Maintenance
- 7 Troubleshooting
- Tools for Troubleshooting
- Locating the Issue
- Installation Troubleshooting
- Card Appearance
- Magnetic Stripe
- Card Jam
- Messages and Conditions
- Respond to Messages
- Printer Component Messages (100-124)
- 100: Request not supported
- 101: Job could not complete
- 102: Card not in position
- 103: Printer problem
- 104: Critical problem
- 105: Magstripe data error
- 106: Magstripe data not found
- 107: Magstripe read data error
- 108: Magstripe read no data
- 111: Card not picked
- 112: Hopper Empty
- 113: Close cover to continue
- 114: Cover opened during job
- 116: Magstripe not available
- 117: Reader not available
- 120: User paused the printer
- 122: Magnetic stripe format problem
- 123: Insert new card then continue
- 124: Insert same card then continue
- Embosser Component Messages (125-151)
- 125: Emboss critical issue
- 126: Emboss format issue
- 127: Emboss transport error
- 128: Embosser card jam
- 129: Embosser topper jam
- 130: Embosser card entry jam
- 131: Embosser card exit jam
- 132: Embosser card stack full
- 133: Embosser card reject full
- 135: Indent ribbon supplies out
- 136: Indent ribbon break
- 137: Embosser wheel error
- 138: Embosser indent error
- 139: Lost card, open emboss cover
- 140: Embosser not available
- 141: Close emboss cover
- 142: Emboss cover error
- 143: Topper ribbon problem
- 144: Topper ribbon out
- 145: Topper ribbon type problem
- 146: Topper ribbon support err.
- 147: Topper ribbon no tag found
- 149: Option not installed
- Printer Component Messages (100-124)
- 8 Supplies and Parts
- 9 Legal Notices
CE870 Card Personalization System Installation and User Guide 85
Chapter 8: Supplies and Parts
The chapter contains information for the
replacement products available for the CE870 Card
Personalization System.
This section describes:
• Supplies
• Cards
• Replacement Parts
Supplies
Indent ribbon, topping foil and system cleaning supplies are available from your
dealer. For best results, run a cleaning card and replace the cleaning sleeve after
every 500 cards processed by the system.
Indent Ribbon
The following indent ribbons are available:
• Ribbon, black, minimum 250 images per roll (Part No. 504461-001).
• Ribbon, white, minimum 250 images per roll (Part No. 504461-002).
• Ribbon, paneled back and white, minimum 250 images per roll (Part No.
50446-110).
Topping Foil
The following topping foils are available:
• Foil, dark blue, minimum 250 cards per roll (Part No. 504139-001).
• Foil, black, minimum 250 cards per roll (Part No. 504139-002).
• Foil, gold, minimum 250 cards per roll (Part No. 504139-003).
• Foil, white, minimum 250 cards per roll (Part No. 504139-004).
• Foil, silver, minimum 250 cards per roll (Part No. 504139-013).