User's Manual
Table Of Contents
- Cover
- Contents
- 1 Welcome to the Card Personalization System
- 2 Installation Requirements
- 3 Install the System
- 4 Using the System
- 5 Card Design
- 6 System Maintenance
- 7 Troubleshooting
- Tools for Troubleshooting
- Locating the Issue
- Installation Troubleshooting
- Card Appearance
- Magnetic Stripe
- Card Jam
- Messages and Conditions
- Respond to Messages
- Printer Component Messages (100-124)
- 100: Request not supported
- 101: Job could not complete
- 102: Card not in position
- 103: Printer problem
- 104: Critical problem
- 105: Magstripe data error
- 106: Magstripe data not found
- 107: Magstripe read data error
- 108: Magstripe read no data
- 111: Card not picked
- 112: Hopper Empty
- 113: Close cover to continue
- 114: Cover opened during job
- 116: Magstripe not available
- 117: Reader not available
- 120: User paused the printer
- 122: Magnetic stripe format problem
- 123: Insert new card then continue
- 124: Insert same card then continue
- Embosser Component Messages (125-151)
- 125: Emboss critical issue
- 126: Emboss format issue
- 127: Emboss transport error
- 128: Embosser card jam
- 129: Embosser topper jam
- 130: Embosser card entry jam
- 131: Embosser card exit jam
- 132: Embosser card stack full
- 133: Embosser card reject full
- 135: Indent ribbon supplies out
- 136: Indent ribbon break
- 137: Embosser wheel error
- 138: Embosser indent error
- 139: Lost card, open emboss cover
- 140: Embosser not available
- 141: Close emboss cover
- 142: Emboss cover error
- 143: Topper ribbon problem
- 144: Topper ribbon out
- 145: Topper ribbon type problem
- 146: Topper ribbon support err.
- 147: Topper ribbon no tag found
- 149: Option not installed
- Printer Component Messages (100-124)
- 8 Supplies and Parts
- 9 Legal Notices
60 System Maintenance
Run a Cleaning Card
Run a cleaning card to clean debris from the inside of the printer system. The
cleaning card can remove most contaminants from the print system. Run a
cleaning card after every 250 cards processed by the printer system or every 6
months.
Begin with the printer displaying Ready. The U
SER button shows steady green.
1. Remove the print ribbon cartridge.
A. Unlock and open the printer
supplies access door.
B. Open the printer cover and remove
the print ribbon cartridge.
C. Close the printer cover, then close
and lock the printer supplies access
door. The front panel should
display Ready and the U
SER button
shows steady green.
2. Enter the menu system.
A. Press and hold the U
SER button.
Suspended is displayed on line 1 of the LCD panel.
B. Press the E
NTER key to enter the menu system.
3. Enter the Cleaning Card menu.
A. Press the down arrow key until Maintenance displays on line 2 of the LCD
panel.
B. Press the E
NTER key to enter the Maintenance menu.